Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM33K0E _53 Suspension _043531 REAR SUSPENSION _0226854 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear upper arm removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Rear height control sensor sub-assembly LH Headlight leveling ECU assembly initialization Headlight leveling function (Click here)


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89408C 2.DISCONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)

a.
C324621

Remove the nut and disconnect the rear height control sensor sub-assembly LH from the upper control arm assembly.


Hide 48710 3.REMOVE UPPER CONTROL ARM ASSEMBLY

C334041

a.

Remove the 2 bolts, 2 nuts and upper control arm assembly from the axle housing.

HINT:

While fixing the nuts in place, loosen and remove the bolts.