Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM33K0E _53 Suspension _043531 REAR SUSPENSION _0226857 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear stabilizer bar removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation Headlight leveling ECU assembly initialization Headlight leveling function (Click here)


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48840A 2.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C324626

Remove the 2 nuts and rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 48830D 3.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 48823C 4.REMOVE REAR STABILIZER BRACKET COVER

a.
C324627

Remove the 2 bolts, 2 nuts and 2 rear stabilizer bracket covers.


Hide 48818 5.REMOVE REAR STABILIZER BUSH

a.

Remove the 2 rear stabilizer bushes.


Hide 48812 6.REMOVE REAR STABILIZER BAR

a.

Remove the rear stabilizer bar.