Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY(for TMMIN Made)
RM33K0E _52 Drivetrain _043594 DRIVE SHAFT / PROPELLER SHAFT _0226980 FRONT PROPELLER SHAFT ASSEMBLY(for TMMIN Made) A

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY(for TMMIN Made)  INSTALLATION  


PROCEDURE

Hide 37140 1.INSTALL FRONT PROPELLER SHAFT ASSEMBLY

NOTICE:

Refer to the components illustration for the installation direction of the front propeller shaft assembly.


a.

Completely remove any oil, etc and clean the contact surfaces of the 2 propeller shaft flanges, differential flange and transfer flange.


b.

Align the matchmarks on the propeller shaft flange and differential flange.


c.

Install the front propeller shaft assembly with the 4 nuts, 4 bolts and 4 washers.

Torque:
88.2 N*m (899 kgf*cm, 65 ft.*lbf)


d.

Align the matchmarks on the propeller shaft flange and transfer flange.


e.

Install the front propeller shaft assembly with the 4 washers and 4 nuts.

Torque:
88.2 N*m (899 kgf*cm, 65 ft.*lbf)


Hide 51561D 2.INSTALL PROPELLER SHAFT GUARD

a.

Install the propeller shaft guard bracket LH with the 2 bolts.

HINT:
·

Perform this procedure only when replacement of the propeller shaft guard bracket is necessary.

·

Use the same procedure for the RH and LH sides.



Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


b.

Install the front propeller shaft guard with the 2 bolts.

Torque:
36.2 N*m (369 kgf*cm, 27 ft.*lbf)


Hide 51407A 3.INSTALL NO. 3 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Cover)

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)