Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
71910A
1.REMOVE FRONT SEAT HEADREST ASSEMBLY
Remove the front seat headrest assembly.
71849
2.REMOVE SEAT ADJUSTER COVER CAP LH
|
Remove in this Direction |
Remove the 2 seat adjuster cover caps LH in the removal direction shown in the illustration.
72526E
3.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
|
Remove in this Direction |
|
Protective Tape |
With the reclining adjuster release handle LH pulled up.
Using a thin-bladed screwdriver with its tip wrapped in protective tape, detach the claw and remove the reclining adjuster release handle LH while moving it in removal direction shown in the illustration.
72495
4.REMOVE VERTICAL ADJUSTING HANDLE LH
Remove the screw.
|
Remove in this Direction |
Detach the guide, and then pull out removal direction shown in the illustration to remove the vertical adjusting handle LH.
71812D
5.REMOVE FRONT SEAT CUSHION SHIELD LH
|
Remove in this Direction |
Using moulding remover A, lift in direction indicated by the arrow shown in the illustration and push down in the removal direction to detach the claw.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position shown in the illustration and pull out removal direction to detach the guide, claw and clip.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position shown in the illustration and pull out removal direction to detach the claw and clip to remove the front seat cushion shield LH.
71862
6.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
|
Remove in this Direction |
Using moulding remover A, lift in direction indicated by the arrow shown in the illustration and push down in removal direction to detach the claw.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position shown in the illustration and pull out removal direction to detach the claw and guide to remove the front seat inner cushion shield LH.
73240
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71014S
8.REMOVE FRONT SEATBACK FRAME SUB-ASSEMBLY LH
Remove the band in the position shown in the illustration.
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
w/ Front Seat Side Airbag:
Detach the wire harness clamp and connector clamp.
| *A | RH Side |
| *B | LH Side |
| *1 | Separate Type Front Seat Cushion Cover |
Detach the hook.
| *A | RH Side |
| *B | LH Side |
Remove the 4 bolts and front seatback frame sub-assembly LH.
71876G
9.REMOVE RECLINING ADJUSTER INSIDE COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Rotate the part in removal direction (1) shown in the illustration to detach the guide.
Pull up in removal direction (2) shown in the illustration to remove the reclining adjuster inside cover LH.
71875F
10.REMOVE RECLINING ADJUSTER INSIDE COVER RH
Use the same procedure as for the LH side.
71759C
11.REMOVE FRONT NO. 1 SEATBACK HOOK
Using moulding remover A, lift in the direction indicated by the arrow shown in the illustration to detach the claw and remove the front No. 1 seatback hook.
71931
12.REMOVE FRONT SEAT HEADREST SUPPORT
Remove the 5 hog rings.
|
Remove in this Direction |
Open the fasteners as shown in the illustration.
|
Remove in this Direction |
Pull up removal direction shown in the illustration to detach the guide to the 2 straps.
|
Remove in this Direction |
Detach the claw and remove the 2 front seat headrest supports.
13.REMOVE SEATBACK COVER WITH PAD
w/ Front Seat Side Airbag:
Place your hand at the position shown in the illustration and pull out the removal direction to detach the J hook B.
| *1 | J Hook A | *2 | J Hook B |
| *3 | J Hook C | - | - |
|
Place Hand Here |
|
Remove in this Direction |
Remove the rivet from J hook B.
| *A | for LH seat | *B | for RH seat |
| *1 | J Hook A | *2 | J Hook B |
Only remove one of the rivets.
For LH seats, remove the top rivet.
For RH seats, remove the bottom rivet.
| *1 | J Hook B (J Hook A and J Hook B) |
| *2 | J Hook C |
|
Remove in this Direction |
Pull out removal direction shown in the illustration to detach the J hook C to J hook B (J hook A and J hook B).
| *1 | J Hook A |
| *2 | J Hook B |
|
Remove in this Direction |
Pull out removal direction shown in the illustration to detach the J hook A to J hook B.
|
Remove in this Direction |
Pull out removal direction shown in the illustration to remove the seatback cover with pad.
71073S
14.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 6 hog rings.
15.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
73920A
16.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (w/ Front Seat Side Airbag)
71759D
17.REMOVE FRONT NO. 2 SEATBACK HOOK
|
Remove in this Direction |
Pull down removal direction shown in the illustration to detach the claw and remove the 2 front No. 2 seatback hooks.
71054S
18.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY LH
Detach the claw and remove the 2 front seatback edge protectors.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull out removal direction (1) shown in the illustration to separate the front seat spring sub-assembly LH.
Pull down removal direction (2) shown in the illustration to remove the front seat spring sub-assembly LH.
Remove the 2 front No. 2 seatback hooks.
71587B
19.REMOVE FRONT SEATBACK EDGE PROTECTOR
|
Protective Tape |
Using a thin-bladed screwdriver with its tip wrapped in protective tape, detach the claw and remove the 2 front seatback edge protectors.
20.REMOVE SEAT CUSHION COVER WITH PAD
While sliding the part in the direction indicated by the arrow shown in the illustration, detach the J hook and remove the seat cushion cover with pad.
71071S
21.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 hog rings and disconnect the 2 straps of the separate type front seat cushion cover from the separate type front seat cushion pad.
Remove the 18 hog rings and separate type front seat cushion cover.
22.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
71874
23.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
|
Remove in this Direction |
Remove the screw.
Pull out removal direction shown in the illustration to detach the guide.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Lift up removal direction (1) shown in the illustration to detach the clip.
Pull out removal direction (2) shown in the illustration to remove the front seat lower cushion shield LH.
71873
24.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
Use the same procedure as for the LH side.
71538B
25.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the screw.
While rotating the part in removal direction (1) shown in the illustration, detach the claw.
Pull out removal direction (2) shown in the illustration to detach the guide and remove the front seat cushion edge protector LH.
71537G
26.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH
Use the same procedure as for the LH side.
71052A
27.REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull out removal direction (1) shown in the illustration to detach the hook.
While rotating the part in removal direction (2) shown in the illustration, detach the hook and remove the front seat cushion spring sub-assembly LH.
72201B
28.REMOVE SEAT TRACK HANDLE SUB-ASSEMBLY LH
Detach the claw and remove the seat track handle sub-assembly LH.