Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM33K0E _58 Vehicle Interior _043553 SEAT _0227126 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY LH

a.
B439080

Place the front seat assembly LH in the vehicle, as shown in the illustration.

NOTICE:

Do not damage the front seat assembly LH, body exterior or interior parts.



b.
B433045

Attach the wire harness clamp.


c.

Connect the connector.


d.

w/ Front Seat Side Airbag:

Connect the front seat airbag assembly LH connector.


e.

Temporarily install the front seat assembly LH with the 4 bolts.


f.

Operate the seat track handle sub-assembly LH to slide the front seat assembly LH rearmost position.


g.
B433044N05
1.573,1.146 1.802,1.344 0.229,0.198 10 true (1) 0.823,0.396 1.052,0.594 0.229,0.198 10 true (2)

Tighten the 2 bolts on the front side of front seat assembly LH in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


h.

Operate the seat track handle sub-assembly LH to slide the front seat assembly LH to the frontmost position.


i.
B433043N03
0.74,1.698 0.979,1.906 0.24,0.208 10 true (1) 2.948,0.26 3.188,0.469 0.24,0.208 10 true (2)

Tighten the 2 bolts on the rear side of front seat assembly LH in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 72138H 2.INSTALL FRONT SEAT REAR INNER TRACK COVER LH

a.
B433048C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Push in installation direction (1) shown in the illustration to attach the guide.


b.

Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear inner track cover LH.


Hide 72138J 3.INSTALL FRONT SEAT REAR OUTER TRACK COVER LH

a.
B433049C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Push in installation direction (1) shown in the illustration to attach the guide.


b.

Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear outer track cover LH.


c.

Operate the seat track handle sub-assembly LH to slide the front seat assembly LH to the center position.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 5.PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Front Seat Side Airbag)

Hide 6.CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)