Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
71694
1.REMOVE REAR SEAT LOWER CUSHION HINGE COVER LH
|
Remove in this Direction |
Remove the screw.
Pull up in removal direction shown in the illustration to detach the claw and guide and remove the rear seat lower cushion hinge cover LH.
72526C
2.REMOVE NO. 2 RECLINING ADJUSTER RELEASE HANDLE LH
| *1 | Rear Seatback Lock Release Button |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the rear seatback lock release button.
Pull the No. 2 reclining adjuster release handle LH in the removal direction (1) to pull it out of the rear seat lower cushion hinge cover LH.
Pull and remove the No. 2 reclining adjuster release handle LH in the removal direction (2).
72526E
3.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
|
Remove in this Direction |
|
Protective Tape |
With the reclining adjuster release handle LH pulled up.
Using a thin-bladed screwdriver with its tip wrapped in protective tape, detach the claw and remove the reclining adjuster release handle LH while moving it in the removal direction shown in the illustration.
71844A
4.REMOVE REAR NO. 2 SEAT RECLINING COVER LH
Remove the screw.
|
Remove in this Direction |
Remove the screw.
Pull in remove direction shown in the illustration to detach the claw and guide and remove the Rear No. 2 seat reclining cover LH.
79393
5.REMOVE REAR NO. 2 SEATBACK CUSHION
Remove the screw and rear No. 2 seatback cushion.
71931C
6.REMOVE REAR NO. 2 SEAT HEADREST SUPPORT ASSEMBLY
While sliding the part in the direction indicated by the arrow shown in the illustration to detach the J hook.
|
Remove in this Direction |
Detach the claw and pull in the removal direction shown in the illustration to remove the 2 rear No. 2 seat headrest support assemblies.
7.REMOVE SEATBACK COVER WITH PAD
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull out the rear end of the seatback cover with pad in removal direction (1) shown in the illustration.
Lift in removal direction (2) shown in the illustration to remove the seatback cover with pad.
79024
8.REMOVE NO. 2 SEATBACK COVER SUB-ASSEMBLY LH
Remove the 3 hog rings and No. 2 seatback cover sub-assembly LH.
9.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
79952
10.REMOVE NO. 2 SEAT CUSHION COVER
Pull out the rear seat cushion lock hook sub-assembly LH from the rear end of the seat cushion cover with pad.
While sliding the part in the direction indicated by the arrow shown in the illustration to detach the J hook.
Remove the clip.
Remove the screw.
| *A | for Front Side |
Remove the 2 screws.
| *A | for Rear Side |
Remove the No. 2 seat cushion cover with 2 screws.
72066A
11.REMOVE REAR SEAT CUSHION LOCK HOOK SUB-ASSEMBLY LH
| *1 | Rear Seat Cushion Band LH |
Remove the rear seat cushion band LH and rear seat cushion lock hook sub-assembly LH.
79378B
12.REMOVE NO. 3 SEAT CUSHION HINGE COVER LH
|
Remove in this Direction |
Detach the clip.
Pull up in remove direction shown in the illustration to detach the claw and guide and remove the No. 3 seat cushion hinge cover LH.
13.REMOVE SEAT CUSHION COVER WITH PAD
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull up both sides of the seat cushion cover with pad in the removal direction (1).
Lift up the front end of the seat cushion cover with pad in the removal direction (2) to remove it.
79022
14.REMOVE NO. 2 CUSHION COVER SUB-ASSEMBLY LH
Remove the 6 hog rings and disconnect the 2 straps of the No. 2 cushion cover sub-assembly LH from the No. 2 seat cushion pad LH.
Remove the 8 hog rings and No. 2 cushion cover sub-assembly LH.
15.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
71694
16.REMOVE REAR SEAT LOWER CUSHION HINGE COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While rotating the part in removal direction (1) shown in the illustration, detach the claw.
While rotating the part in removal direction (2) shown in the illustration, detach the claw and remove the rear seat lower cushion hinge cover LH.
79225B
17.REMOVE REAR NO. 2 SEAT CUSHION CARPET LH
|
Remove in this Direction |
Move the rear No. 2 seat leg assembly LH as shown in the illustration.
Detach the clip and remove the rear No. 2 seat cushion carpet LH.
73580A
18.REMOVE REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY
79040B
19.REMOVE REAR NO. 2 SEAT LEG ASSEMBLY LH
| *1 | Protective Tape |
|
Remove in this Direction |
Move a screwdriver with its tip wrapped with protective tape in the direction indicated by the arrow to widen and remove the 3 wiring harness clamps as shown in the illustration.
| *1 | Cable End |
|
Remove in this Direction |
for LH side:
Detach the casing cap.
Turn the cable end in the removal direction shown in the illustration and disconnect the cable end.
| *1 | Cable End |
|
Remove in this Direction |
for RH side:
Detach the casing cap.
Turn the cable end in the removal direction shown in the illustration and disconnect the cable end.
| *1 | Protective Tape |
|
Remove in this Direction |
Move a screwdriver with its tip wrapped with protective tape in the direction indicated by the arrow to widen and remove the hook of the spring clamp as shown in the illustration.
Remove the 2 bolts and rear No. 2 seat leg assembly LH.
79236A
20.REMOVE NO. 2 SEAT LEG COVER
| *1 | Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped with protective tape, pry the No. 2 seat leg cover in the removal direction (1) to detach the guide and clip.
Pry in the removal direction (2) to detach the claw and remove the No. 2 seat leg cover.
72695C
21.REMOVE REAR SEAT LOCK CONTROL CABLE LH
|
Protective Tape |
Move a screwdriver with its tip wrapped with protective tape in the direction indicated by the arrow shown in the illustration to remove the spring.
Detach the clamp.
| *1 | Cable End |
|
Remove in this Direction |
Detach the casing cap.
Turn the cable end in the removal direction shown in the illustration and disconnect the cable end to remove the rear seat lock control cable LH.
71692B
22.REMOVE REAR OUTER SEAT LOCK COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull in the removal direction (1) shown in the illustration to detach the guide.
Pull in the removal direction (2) shown in the illustration to remove the rear outer seat lock cover LH.
71304B
23.REMOVE REAR NO. 2 SEAT HINGE SUB-ASSEMBLY LH
|
Remove in this Direction |
Remove the 2 bolts.
Pull in the removal direction shown in the illustration to remove the rear No. 2 seat hinge sub-assembly LH.
Remove the spring carefully, as it is still under tension.
79204A
24.REMOVE NO. 2 SEATBACK FRAME SUB-ASSEMBLY LH
| *A | for LH side |
| *B | for RH side |
Using a T55 "TORX" socket wrench, remove the 4 "TORX" bolts and rear No. 2 seat hinge sub-assembly LH.