Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR NO. 2 SEAT ASSEMBLY LH
| *1 | Location Pin |
Insert the location pin of the outer side into the hole in the body to lock the rear No. 2 seat leg assembly LH to the floor striker.
Protect the front seat legs.
Do not damage the rear No. 2 seat assembly LH, body exterior or interior parts.
Install the part with the seatback folded forward.
Install the 2 pop-up prevention bolts.
Tighten the 3 bolts in the order shown in the illustration to install the rear No. 2 seat assembly LH.
Remove the 2 pop-up prevention bolts.
71849C
2.INSTALL SEAT ADJUSTER COVER CAP LH
|
Install in this Direction |
Push as shown in the illustration to attach the claw and guide and install the seat adjuster cover cap LH.
72928
3.INSTALL REAR SEAT CUSHION UNDER COVER LH
|
Install in this Direction |
Set the rear No. 2 seat assembly LH to the upright position.
Push as shown in the illustration to attach the clip and install the rear seat cushion under cover LH.
Install the 2 hole plugs.
Lock the rear No. 2 seat leg assembly LH to the floor striker and set the rear No. 2 seat to the upright position.
71940E
4.INSTALL NO. 2 SEAT HEADREST ASSEMBLY
|
Apply silicon |
|
Lubricant in this range. |
Apply silicon lubricant at the positions shown in the illustration and install the No. 2 seat headrest assembly.