85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
With the engine switch turned on (IG), check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 184 mm (7.2441 in.) | B | 215 mm (8.4646 in.) |
| C | 115 mm (4.5276 in.) | D | 197 mm (7.7559 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.