Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM33K0E _52 Drivetrain _043529 VF2CM TRANSFER / 4WD / AWD _0227239 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

VF2CM TRANSFER / 4WD / AWD  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  P17A0  Automatic Disconnecting Differential Motor Control Circuit Open  


DESCRIPTION

This DTC is output when an open circuit in the A.D.D. shift motor drive circuit is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17A0 Automatic Disconnecting Differential Motor Control Circuit Open
·

Diagnosis Condition: While switching between H2 and H4 (A.D.D. shift motor operating) with the ignition switch turned to ON

·

Malfunction Status: Open circuit in the A.D.D. shift motor drive circuit

·

Malfunction Time: 0.03 seconds or more

·

Other: 1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

A.D.D. actuator (differential motor actuator assembly)



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL MOTOR ACTUATOR ASSEMBLY)
a.

Disconnect the C61 4 wheel drive control ECU connector.


b.

Disconnect the C57 A.D.D. actuator (differential motor actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C61-2 (DM1) - C57-1 (DM1) Always Below 1 Ω
C61-6 (DM2) - C57-2 (DM2) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

2.INSPECT DIFFERENTIAL MOTOR ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT DIFFERENTIAL MOTOR ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)
a.
C290971C02
1.833,2.323 2.104,1.875 true 2.521,2.333 2.365,1.896 true 0.177,0.135 0.49,0.333 0.313,0.198 10 false *a 2.458,2.354 2.917,2.552 0.458,0.198 10 false DM1 1.635,2.344 2.094,2.542 0.458,0.198 10 false DM2
*a Component without harness connected
(A.D.D. Actuator (Differential Motor Actuator Assembly))


Disconnect the C57 A.D.D. actuator (differential motor actuator assembly) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (DM1) - 2 (DM2) Always 1.5 to 10 Ω



Result:
Proceed to
OK
NG



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG