When the transfer position switch is switched, the 2-4 terminal and LO terminal change to one of the following ON/OFF combinations listed in the table below.
| Terminal | H2 | Between H2 and H4 | H4 | Between H4 and L4 | L4 |
|---|---|---|---|---|---|
| 2-4 | ON | OFF | ON | OFF | OFF |
| LO | OFF | OFF | ON | OFF | ON |
This DTC is detected if the transfer position switch 2-4 terminal and LO terminal signals are simultaneously received.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P279E | Four Wheel Drive (4WD) Range Signal Circuit Range / Performance | ·
Diagnosis Condition: Ignition switch turned to ON ·
Malfunction Status: The ON/OFF combination of the 2-4 terminal and LO terminal does not match the pattern ·
Malfunction Time: 60 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer position switch |
Disconnect the C60 4 wheel drive control ECU connector.
Disconnect the G11 transfer position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C60-14 (2-4) - G11-5 (2-4) | Always | Below 1 Ω |
| C60-13 (LO) - G11-2 (LO) | Always | Below 1 Ω |
| G11-4 (GND) - Body ground | Always | Below 1 Ω |
| C60-14 (2-4) or G11-5 (2-4) - Body ground | Always | 10 kΩ or higher |
| C60-13 (LO) or G11-2 (LO) - Body ground | Always | 10 kΩ or higher |
| C60-14 (2-4) or G11-5 (2-4) - C60-13 (LO) or G11-2 (LO) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Transfer Position Switch) |
Remove the transfer position switch with its connector still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G11-5 (2-4) - Body ground | Ignition switch ON
H2 position |
Below 1.5 V |
| Ignition switch ON
H4 position |
Below 1.5 V | |
| Ignition switch ON
L4 position |
10 to 14 V | |
| G11-2 (LO) - Body ground | Ignition switch ON
H2 position |
10 to 14 V |
| Ignition switch ON
H4 position |
Below 1.5 V | |
| Ignition switch ON
L4 position |
Below 1.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG