This DTC is output when a malfunction is detected due to a battery short occurring in the differential lock coil drive circuit of the rear differential.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P17C1 | Rear Differential Lock Solenoid Circuit High | ·
Diagnosis Condition: Directly after ignition switch is turned to ON, or when rear differential is switched between free and locked (differential lock coil operating) with ignition switch turned to ON ·
Malfunction Status: Battery short in differential lock coil drive circuit ·
Malfunction Time: 0.05 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Differential lock coil |
Refer to DTC P17C0.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>P17C0
Disconnect the C61 4 wheel drive control ECU connector.
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C61-1 (SL+) or C61-5 (SL-) - Body ground | Ignition switch ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C61 4 wheel drive control ECU connector.
Disconnect the F1 differential lock coil connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C61-1 (SL+) or F1-2 (M1) - Body ground | Ignition switch ON | Below 1 V |
| C61-5 (SL-) or F1-1 (M2) - Body ground | Ignition switch ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
w/ Differential Lock: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock)>DISASSEMBLY
for DANA Made w/ Differential Lock: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made w/ Differential Lock)>DISASSEMBLY
NG