Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM(w/ Differential Lock)
RM33K0E _52 Drivetrain _043595 AXLE AND DIFFERENTIAL _0227240 DIFFERENTIAL SYSTEM(w/ Differential Lock) C

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM(w/ Differential Lock)  P17BC  Rear Differential Lock Position SW Stuck ON  


DESCRIPTION

This DTC is output when an ON malfunction of the rear differential lock position switch (No. 1 transfer indicator switch) is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17BC Rear Differential Lock Position SW Stuck ON
·

Diagnosis Condition: Ignition switch turned to ON

·

Malfunction Status: Rear differential lock position switch (No. 1 transfer indicator switch) is stuck ON

·

Malfunction Time: 2 seconds or more

·

Other: 1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Rear differential lock position switch (No. 1 transfer indicator switch)



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - NO. 1 TRANSFER INDICATOR SWITCH)
a.

Disconnect the C60 4 wheel drive control ECU connector.


b.

Disconnect the F2 rear differential lock position switch (No. 1 transfer indicator switch) connector.


c.

w/o VSC:

Disconnect the A3 skid control ECU (brake actuator assembly) connector.

w/ VSC:

Disconnect the A4 skid control ECU (brake actuator assembly) connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C60-12 (SLS) or F2-2 (RLY2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH
a.

for Automatic Transmission:

Move the shift lever to N.

for Manual Transmission:

Move the shift lever to neutral.


b.

except Pre-Runner:

Switch the transfer position switch to L4.


c.

Lift up the vehicle until all four wheels are off the ground.


d.

Release the parking brake.


e.

Rotate one rear wheel and set the rear differential to the free condition.


f.

Disconnect the F2 rear differential lock position switch (No. 1 transfer indicator switch) connector.


g.
E121181C01
1.448,1.313 0.938,1.76 true 2.052,1.333 2.667,1.677 true 0.198,0.177 0.51,0.375 0.313,0.198 10 false *a 0.5,1.677 1.115,1.875 0.615,0.198 10 false RLY2 2.677,1.635 3.135,1.833 0.458,0.198 10 false GND
*a Component without harness connected
(Rear Differential Lock Position Switch (No. 1 Transfer Indicator Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (RLY2) - 1 (GND) Rear differential free 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG