Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(w/o Turn Over)
RM33K0E _52 Drivetrain _043527 CLUTCH _0227291 CLUTCH MASTER CYLINDER(w/o Turn Over) A

CLUTCH  CLUTCH MASTER CYLINDER(w/o Turn Over)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the lock nut and master cylinder push rod clevis to the push rod.

HINT:

Tighten the lock nut to the specified torque when adjusting the clutch pedal.



Hide 31410 2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install a new gasket and the clutch master cylinder assembly with the 2 nuts.

Torque:
18.4 N*m (188 kgf*cm, 14 ft.*lbf)


Hide 3.CONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 31481 4.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C333656C01
1.635,2.135 1.948,2.292 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the clutch master cylinder to flexible hose tube.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 31434 5.CONNECT CLUTCH RESERVOIR TUBE

a.

Connect the clutch reservoir tube to the clutch master cylinder assembly, and slide the clip to secure it.

NOTICE:

Connect the clutch reservoir hose so that it is not twisted.



Hide 6.BLEED AIR FROM CLUTCH PIPE LINE

Hide 7.CHECK FOR CLUTCH FLUID LEAKAGE

HINT:

Check for leaks in the clutch system.


Hide 31301 8.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY

Hide 9.CHECK FLUID LEVEL IN RESERVOIR