This circuit consists of the sensor power supply, sensor ground and sensor signal wires between the clearance warning ECU assembly and ultrasonic sensors. The ultrasonic sensors are digital sensors.
Disconnect the G88 clearance warning ECU assembly connector.
Disconnect the P2 No. 1 ultrasonic sensor (rear right center) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G88-12 (BOR) - P2-1 (BI) | Always | Below 1 Ω |
| G88-14 (SOR) - P2-3 (SI) | Always | Below 1 Ω |
| G88-13 (E1) - P2-5 (EI) | Always | Below 1 Ω |
| G88-12 (BOR) or P2-1 (BI) - Body ground | Always | 10 kΩ or higher |
| G88-14 (SOR) or P2-3 (SI) - Body ground | Always | 10 kΩ or higher |
| G88-13 (E1) or P2-5 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the P2 No. 1 ultrasonic sensor (rear right center) connector.
Disconnect the P1 No. 1 ultrasonic sensor (rear left center) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P2-2 (BO) - P1-1 (BI) | Always | Below 1 Ω |
| P2-4 (SO) - P1-3 (SI) | Always | Below 1 Ω |
| P2-6 (EO) - P1-5 (EI) | Always | Below 1 Ω |
| P2-2 (BO) or P1-1 (BI) - Body ground | Always | 10 kΩ or higher |
| P2-4 (SO) or P1-3 (SI) - Body ground | Always | 10 kΩ or higher |
| P2-6 (EO) or P1-5 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the No. 1 ultrasonic sensor.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR>REMOVAL
Inspect the No. 1 ultrasonic sensor.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG