Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER
RM33K0E _51 Engine / Hybrid System _043587 1GR-FE STARTING _0227371 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882F 3.REMOVE FRONT FENDER SEAL LH

Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A343649

Disconnect the starter connector.


b.

Remove the bolt and disconnect the starter wire from the cylinder block.


c.

Disconnect the terminal cap.


d.

Remove the nut and disconnect the starter wire.


e.

Remove the bolt and disconnect the wire harness bracket.


f.
A343650

Remove the 2 bolts and starter assembly.


Hide 11363A 5.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A222907

Remove the flywheel housing side cover from the cylinder block.