CHECK INDICATOR/WARNING LIGHT
Check the following indicators and warning lights.
| Indicator/Warning Light | Switch Condition | Specified Condition |
|---|---|---|
| Brake override system warning light | Ignition switch off → ON | Comes on for 3 seconds |
| Brake warning light | ||
| Slip indicator light (w/ VSC) | ||
| VSC OFF indicator light (w/ VSC) | ||
| TRC OFF indicator light (w/ VSC) | ||
| ABS warning light (w/ ABS) | ||
| Fuel system warning light (for Diesel Engine) | ||
| Downhill assist control system indicator light (w/ Downhill Assist Control) | ||
| iMT indicator light (for Intelligent Manual Transmission) | ||
| Eco driver indicator light (w/ Eco Drive Indicator Light) | ||
| T-BELT indicator light (for 1KD-FTV) | ||
| DPF warning light (w/ DPF) | ||
| SRS warning light | Ignition switch off → ON | Comes on for 6 seconds |
| Low engine oil pressure warning light | Ignition switch off → ON | ·
Illuminates when ignition switch turned ON ·
Turns off when engine started |
| A/T OIL TEMP warning light (for 4WD, Automatic Transmission) | ||
| MIL (Malfunction indicator lamp) | ||
| Low engine oil level warning light (for 1GD-FTV) |
CHECK SPEEDOMETER
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Almost same as actual vehicle speed | - |
| Tester Display |
|---|
| Vehicle Speed |
| Standard Indication (km/h) | Acceptable Range (km/h) |
|---|---|
| 20 | 21 to 25 |
| 40 | 41.7 to 46.2 |
| 60 | 62.7 to 67.2 |
| 80 | 83.4 to 88.4 |
| 100 | 104.3 to 109.3 |
| 120 | 125.1 to 130.6 |
| 140 | 145.8 to 151.8 |
| 160 | 166.2 to 173.2 |
| 180 | 186.9 to 194.5 |
| 200 | 207.7 to 215.7 |
If the result is not as specified, the speedometer may have a malfunction.
Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.
Check the deflection width of the speedometer indicator.
Within 0.3°
CHECK TACHOMETER
Connect a tune-up tachometer and start the engine.
Compare the test results with the tachometer indicator.
| Standard Indication (rpm) | Acceptable Range
Data in ( ) is for Reference (rpm) |
|---|---|
|
*1: for Gasoline Engine *2: for 2TR-FE |
|
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000*1 | (5750 to 6250) |
| 7000*2 | 6700 to 7300 |
If the result is not as specified, the tachometer may have a malfunction.
CHECK METER/GAUGE
Connect the GTS to the DLC3.
Perform the Active Test.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
Each meter/gauge needle indication is normal.
CHECK WARNING/INDICATOR LIGHT
Connect the GTS to the DLC3.
Perform the Active Test.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
Each warning/indicator light can be turned on and off using the GTS.
CHECK MULTI-INFORMATION DISPLAY (except Segment Display Type)
Connect the GTS to the DLC3.
Perform the Active Test.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
All dots in the multi-information display can be turned on and off using the GTS.