Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT(for Center)
RM33K0E _58 Vehicle Interior _043549 LIGHTING (INT) _0227556 ROOM LIGHT(for Center) G

LIGHTING (INT)  ROOM LIGHT(for Center)  INSPECTION  


PROCEDURE

Hide 81360T 1.INSPECT SPOT LIGHT ASSEMBLY (ROOM LIGHT) (for LED Type)

a.

Inspect the spot light switch.

i.
E320544C01
1.188,1.229 0.542,1.094 true 2.24,1.24 2.833,1.135 true 0.094,0.073 0.406,0.229 0.313,0.156 10 false *a 2.896,1.031 3.052,1.229 0.156,0.198 10 false B 0.406,0.979 0.563,1.177 0.156,0.198 10 false E
*a Component without harness connected
(Spot Light Assembly (Room Light))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (B) - 5 (E) Spot light switch OFF 10 kΩ or higher
Spot light switch ON Below 1 Ω


If the result is not as specified, replace the spot light assembly (room light).



b.

Inspect the courtesy switch.

i.
E320544C02
1.5,1.167 1.292,0.417 true 2.229,1.24 2.833,1.135 true 0.094,0.073 0.406,0.229 0.313,0.156 10 false *a 2.885,1.031 3.042,1.229 0.156,0.198 10 false B 1.146,0.24 1.552,0.438 0.406,0.198 10 false CTY
*a Component without harness connected
(Spot Light Assembly (Room Light))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (B) - 4 (CTY) Courtesy switch OFF 10 kΩ or higher
Courtesy switch ON Below 1 Ω


If the result is not as specified, replace the spot light assembly (room light).



c.

Inspect the spot light.

i.
E320544C04
1.938,1.167 2.271,0.385 true 0.552,1.104 1.188,1.26 true 2.229,1.25 2.854,1.125 true 0.094,0.073 0.406,0.229 0.313,0.156 10 false *a 0.406,0.979 0.563,1.177 0.156,0.198 10 false E 2.167,0.198 2.552,0.396 0.385,0.198 10 false RILL 2.917,1.031 3.115,1.229 0.198,0.198 10 false B
*a Component without harness connected
(Spot Light Assembly (Room Light))


Apply battery voltage to the connector and check the light illumination condition.

OK:
Tester Connection Switch Condition Specified Condition
Battery positive (+) → 1 (B)
Battery negative (-) → 5 (E)
Spot light switch ON Spot light illuminates
Battery positive (+) → 2 (RILL)
Battery negative (-) → 5 (E)
Always Switch illuminates


If the result is not as specified, replace the spot light assembly (room light).