Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door)
RM33K0E _59 Vehicle Exterior _043558 WINDOW / GLASS _0229935 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 85720C 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.
B437369

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



c.
B437154

for Front Passenger Side, w/o Jam Protection Function:

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly RH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly RH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69802 2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151C 4.INSTALL FRONT DOOR GLASS RUN LH

Hide 67832 5.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 67602 6.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69284C 7.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 8.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 9.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 74220 10.INSTALL FRONT ARMREST ASSEMBLY LH

Hide 67492A 11.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION