The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor disassembly/reassembly are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Fully open the front door glass sub-assembly LH before proceeding with work.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
74220
4.REMOVE FRONT ARMREST ASSEMBLY LH
5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
69284C
7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
67602
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68151C
10.REMOVE FRONT DOOR GLASS RUN LH
68102
11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
69802
12.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720C
13.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.
for Front Passenger Side, w/o Jam Protection Function:
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.