Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › TRANSPONDER KEY AMPLIFIER
RM33K0E _58 Vehicle Interior _043548 THEFT DETERRENT / KEYLESS ENTRY _0230261 TRANSPONDER KEY AMPLIFIER A

THEFT DETERRENT / KEYLESS ENTRY  TRANSPONDER KEY AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the transponder key amplifier removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system Click here(Click here)

CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45287 3.REMOVE STEERING COLUMN LOWER COVER

Hide 45286B 4.REMOVE STEERING COLUMN UPPER COVER

Hide 89782 5.REMOVE TRANSPONDER KEY COIL

a.
E339759C01
0,0 0,0 false
V113147

Remove in this Direction


Using a screwdriver, widen the claw attached to the upper bracket by approximately 1.0 mm (0.039 in.).


b.

Pull out the transponder key coil with the claws open.


c.

Disconnect the connector and transponder key coil.