89543
1.INSTALL FRONT SPEED SENSOR LH
Install the skid control sensor clamp to the steering knuckle with the bolt.
Install the speed sensor to the steering knuckle with the bolt.
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
While inserting the speed sensor into the steering knuckle hole, do not strike or damage the sensor tip.
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
When installing the sensor, do not twist the wire harness.
Install the harness clamp with the bolt.
When installing the clamp, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the clamp.
Attach the clamp.
Install the 2 harness clamps with the 2 bolts.
When installing the clamps, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the 2 clamps.
When attaching the clamps, do not twist the wire harness.
Attach the 2 clamps.
When attaching the clamps, do not twist the wire harness.
Connect the connector and attach the clamp.
Do not attach the connector to the radiator fan shroud before connecting the connector.
Securely connect the connector.
89542
2.INSTALL FRONT SPEED SENSOR RH
Install the skid control sensor clamp to the steering knuckle with the bolt.
Install the speed sensor to the steering knuckle with the bolt.
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
When installing the sensor, do not twist the wire harness.
Attach the clamp.
Install the harness clamp with the bolt.
When installing the clamp, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the clamp.
Install the 2 harness clamps with the 2 bolts.
When installing the clamps, do not twist the wire harness.
Make sure the clamp rotation stopper touches the installation position.
Attach the clamp.
Attach the 2 clamps.
When attaching the clamps, do not twist the wire harness.
Attach the 2 clamps.
When attaching the clamps, do not twist the wire harness.
Connect the connector and attach the clamp.
Do not attach the connector to the radiator fan shroud before connecting the connector.
Securely connect the connector.
for 1GD-FTV:
Install the upper arm heat insulator to the front suspension tower with the 2 bolts.
3.INSTALL FRONT WHEEL
4.CHECK SPEED SENSOR SIGNAL