Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ECD SYSTEM(for i-ART)
RM33K0E _51 Engine / Hybrid System _043518 1GD-FTV ENGINE CONTROL _0245023 ECD SYSTEM(for i-ART) D

1GD-FTV ENGINE CONTROL  ECD SYSTEM(for i-ART)  INITIALIZATION  


INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY, ELECTRIC EGR CONTROL VALVE ASSEMBLY AND TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR


HINT:

When the diesel throttle body assembly, electric EGR control valve assembly or turbocharger nozzle vane control actuator is replaced, perform initialization


a.

Turn the engine switch on (IG).

NOTICE:

Do not start the engine.



b.

Turn the engine switch off and wait for 30 seconds or more.


c.

Turn the engine switch on (IG) and wait for 10 seconds or more.



CRANK TIME COMPENSATION RESET FUNCTION


·

This procedure uses the GTS to perform "Crank Time Compensation Reset".

·

When replacing the timing rotor (engine assembly), perform "Crank Time Compensation Reset".


HINT:
·
A204035

If an error occurs during compensation reset, check the vehicle condition, and then perform compensation reset again.

·

A communication malfunction may occur if there is a problem with the ECM, a wire harness or the connection to the DLC3. If the wire harnesses and the connection to the DLC3 are inspected and found to be normal, the ECM may be malfunctioning.



a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).

NOTICE:

Do not start the engine.



c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Utility / Crank Time Compensation Reset.

Powertrain > Engine > Utility
Tester Display
Crank Time Compensation Reset
50005 234 237

e.
A280989

When the first screen is displayed, check the vehicle condition and push "Next".


f.
A280984

When the screen indicating reset completion is displayed, push "Exit".



i-ART Learning Value Reset


NOTICE:
·

When the engine is started after the i-ART learned value is reset with the engine switch on (IG), the value for Injection Feedback Val may indicate a malfunction momentarily. However, this is not a malfunction and is due to the i-ART learned value being reset. The value returns to normal once learning is begun.

·

When the battery cable is disconnected, reconnect the battery cable, turn the engine switch on (IG) and wait 3 minutes or more before performing this procedure.



a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).

NOTICE:

Do not start the engine.



c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Utility / i-ART Learning Value Reset.

Powertrain > Engine > Utility
Tester Display
i-ART Learning Value Reset
50005 234 4257
·

3 minutes or more has elapsed after turning the engine switch on (IG) and connecting the battery cable.

·

The engine is stopped.

·

Battery voltage is 8 V or more.



e.

Select the cylinder to be reset.


f.

Press "Next".

HINT:

The reset is performed automatically after "Next" is selected.



g.

If the reset fails, confirm the following conditions and perform the reset again.

i.

Turn the engine switch on (IG).


ii.

Turn the engine switch off and wait for 30 seconds or more.


iii.

Turn the engine switch on (IG) and wait 3 minutes or more.


iv.

Battery voltage is 8 V or more.



h.

When the screen indicating reset completion is displayed, push "Exit".