Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › from 2016.07
RM33K0E _51 Engine / Hybrid System _054512 2TR-FBE ENGINE CONTROL _0269966 SFI SYSTEM L

2TR-FBE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (refer to the Service Bulletin for registration).

·

Perform initialization (throttle position) after replacing or cleaning the throttle body with motor assembly.

Click hereEngine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION

·

Perform Registration (VIN or frame number registration) when replacing the ECM.

Click hereEngine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>REGISTRATION



HINT:

Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.



WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.



DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

After the ignition switch is turned off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION