Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › THROTTLE BODY › from 2016.07
RM33K0E _51 Engine / Hybrid System _054512 2TR-FBE ENGINE CONTROL _0269969 THROTTLE BODY A

2TR-FBE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 17861 2.REMOVE INTAKE AIR CONNECTOR

a.
A344396

Disconnect the connector and detach the wire harness clamp.


b.

Disconnect the vacuum hose from the air pressure sensor and detach the clamp.


c.
A349271

Slide the clip and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.


d.

Disconnect the vacuum hose.


e.

Slide the clip and disconnect the No. 1 air hose from the intake air connector.


f.
A382762

Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.


Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Disconnect the throttle body with motor connector.


b.

Slide the 2 hose clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.


c.
A382763

Remove the 4 bolts and the throttle body with motor assembly.


d.

Remove the gasket from the intake manifold.