Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.07
RM33K0E _51 Engine / Hybrid System _054512 2TR-FBE ENGINE CONTROL _0269980 HEATED OXYGEN SENSOR A

2TR-FBE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A345943

Disconnect the heated oxygen sensor connector.


b.

Detach the sensor wire from the 4 clamps.


c.
A345944N01
2,0.813 2.25,0.5 2.25,0.5 2.417,0.5 true 2.448,0.417 2.802,0.615 0.354,0.198 10 true SST

Using SST, remove the heated oxygen sensor.

SST
09224-00012