The radio and display receiver assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function.
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective system based on this pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
| *a | Component with harness connected
(Combination Meter Assembly) |
Check the output waveform.
Remove the combination meter assembly with the connector still connected.
Connect an oscilloscope to terminal G8-19 (+S) and body ground.
Turn the ignition switch to ON.
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
|---|---|
| Measurement terminal | G8-19 (+S) - Body ground |
| Tool setting | 5 V/DIV, 20 ms./DIV |
| Vehicle condition | Wheel being rotated |
The waveform is similar to that shown in the illustration.
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
*1: for 1GD-FTV
*2: for 2TR-FE, 2TR-FBE
*3: for 1GR-FE
*4: for 1KD-FTV
Disconnect the G100 radio and display receiver assembly connector.
Disconnect the G8 combination meter assembly connector.
w/ Smart Entry and Start System:
Disconnect the G16 certification ECU (smart key ECU assembly) connector.
Disconnect the G33 body ECU connector.
Disconnect the G49*1, G56*2, G159*3 or G129*4 ECM connector.
for 1KD-FTV with Automatic Transmission:
Disconnect the G132 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G100-17 (SPD) - G8-19 (+S) | Always | Below 1 Ω |
| G100-17 (SPD) or G8-19 (+S) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG