Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) › from 2016.10
RM33K0E _56 Audio / Visual / Telematics _043543 PARK ASSIST / MONITORING _0227354 REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type)  Image from Camera for Rear View Monitor is Abnormal  


DESCRIPTION

The display signal from the rear television camera assembly is transmitted to the navigation receiver assembly.

WIRING DIAGRAM

E320978E01
5.771,0.635 6.229,0.833 0.458,0.198 10 false CA+ 5.771,1.083 6.229,1.281 0.458,0.198 10 false V+ 5.771,1.573 6.229,1.771 0.458,0.198 10 false V- 5.771,2 6.229,2.198 0.458,0.198 10 false CGND 1.135,0.635 1.594,0.833 0.458,0.198 10 false CB+ 1.135,1.094 1.594,1.292 0.458,0.198 10 false CV+ 1.167,1.563 1.625,1.76 0.458,0.198 10 false CV- 1.021,2.01 1.479,2.208 0.458,0.198 10 false CGND 5.469,0.521 5.927,0.719 0.458,0.198 10 false 11 5.458,0.99 5.917,1.188 0.458,0.198 10 false 12 5.479,1.469 5.938,1.667 0.458,0.198 10 false 24 5.479,1.906 5.938,2.104 0.458,0.198 10 false 23 1.542,0.521 2,0.719 0.458,0.198 10 false 6 1.542,0.99 2,1.188 0.458,0.198 10 false 3 1.552,1.479 2.01,1.677 0.458,0.198 10 false 2 1.552,1.906 2.01,2.104 0.458,0.198 10 false 5 5.208,2.469 6.417,2.667 1.208,0.198 10 false G42 5.229,2.635 7.125,2.875 1.896,0.24 10 false Navigation Receiver Assembly 4.594,2.156 5.292,2.333 0.698,0.177 10 false Shielded 3.333,2.156 4.031,2.333 0.698,0.177 10 false Shielded 2.083,2.167 2.781,2.344 0.698,0.177 10 false Shielded 0.052,2.458 1.26,2.656 1.208,0.198 10 false V21 0.052,2.625 2.271,2.823 2.219,0.198 10 false Rear Television Camera Assembly

CAUTION / NOTICE / HINT

HINT:

When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Service.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the G42 navigation receiver assembly connector.


b.

Disconnect the V21 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G42-11 (CA+) - V21-6 (CB+) Always Below 1 Ω
G42-12 (V+) - V21-3 (CV+) Always Below 1 Ω
G42-23 (CGND) - V21-5 (CGND) Always Below 1 Ω
G42-24 (V-) - V21-2 (CV-) Always Below 1 Ω
G42-11 (CA+) or V21-6 (CB+) - Body ground Always 10 kΩ or higher
G42-12 (V+) or V21-3 (CV+) - Body ground Always 10 kΩ or higher
G42-23 (CGND) or V21-5 (CGND) - Body ground Always 10 kΩ or higher
G42-24 (V-) or V21-2 (CV-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK NAVIGATION RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK NAVIGATION RECEIVER ASSEMBLY
a.
E315712C02
1.469,0.219 1.969,0.469 0.5,0.25 0.552,0.385 0.833,0.385 0.833,0.385 1.208,1.021 true 0.604,1.615 0.885,1.615 0.885,1.615 1.063,1.26 true 0.844,1.865 1.125,1.865 1.125,1.865 1.208,1.302 true 0.063,0.031 0.375,0.229 0.313,0.198 10 false *a 0.229,0.302 0.625,0.49 0.396,0.188 10 false CA+ 1.583,0.26 1.896,0.458 0.313,0.198 10 false G42 0.406,1.531 0.719,1.729 0.313,0.198 10 false V- 0.427,1.781 0.958,2 0.531,0.219 10 false CGND
*a Component with harness connected
(Navigation Receiver Assembly)


Remove the navigation receiver assembly with its connectors still connected.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G42-23 (CGND) - Body ground Always Below 1 Ω
G42-24 (V-) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G42-11 (CA+) - Body ground Ignition switch ACC 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

3.CHECK REAR TELEVISION CAMERA ASSEMBLY

NG

3.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Remove the navigation receiver assembly with its connectors still connected.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>REMOVAL

E315713C01
1.417,0.542 1.917,0.792 0.5,0.25 3.938,2.333 3.688,2.333 3.688,2.333 3.594,1.74 true 3.073,2.333 3.323,2.333 3.323,2.333 3.5,1.802 true 6.156,2.333 5.906,2.333 5.906,2.333 5.76,1.635 true 5.24,2.333 5.49,2.333 5.49,2.333 5.646,1.688 true 0.698,2.135 0.948,2.135 0.948,2.135 1.125,1.604 true 0.5,1.396 0.969,1.396 true 0.667,0.417 0.979,0.615 0.313,0.198 10 false *a 1.531,0.583 1.99,0.802 0.458,0.219 10 false G42 2.833,1.344 3.292,1.563 0.458,0.219 10 false GND 4.979,1.344 5.438,1.563 0.458,0.219 10 false GND 2.906,2.25 3.365,2.469 0.458,0.219 10 false *d 3,0.417 3.458,0.635 0.458,0.219 10 false *b 5.167,0.417 5.625,0.635 0.458,0.219 10 false *c 0.302,1.302 0.76,1.521 0.458,0.219 10 false V+ 0.271,2.042 0.76,2.26 0.49,0.219 10 false CGND 3.969,2.24 4.427,2.458 0.458,0.219 10 false *e 5.083,2.25 5.542,2.469 0.458,0.219 10 false *d 6.198,2.229 6.656,2.448 0.458,0.219 10 false *e
*a Component with harness connected
(Navigation Receiver Assembly)
*b Waveform 1
*c Waveform 2 *d Synchronization Signal
*e Video Waveform - -



b.

Check the waveform of the television rear camera assembly using an oscilloscope.

HINT:
·

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly with the connector connected.

·

The video waveform changes according to the image sent by the rear television camera assembly.



Item Content
Terminal No. (Symbol) G42-12 (V+) - G42-23 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Waveform 1: Ignition switch ON, shift lever in R, camera lens not covered, displaying an image
Waveform 2: Ignition switch ON, shift lever in R, camera lens covered, blacking out screen

OK:

Waveform is as shown in the illustration.



Result:
Proceed to
OK
NG



OK

NG

4.CHECK REAR TELEVISION CAMERA ASSEMBLY
4.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA>REMOVAL


b.

Check if the same malfunction recurs when the rear view monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).



Result:
Proceed to
OK
NG



OK

END (REAR TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE)

NG