Home › Vehicle Exterior › BODY WELD POINT › REAR DOOR OUTER PANEL(for Double Cab)
BM3250E _01 Vehicle Exterior _040520 BODY WELD POINT _0187872 REAR DOOR OUTER PANEL(for Double Cab) F

BODY WELD POINT  REAR DOOR OUTER PANEL(for Double Cab)  CUT AND JOIN REPLACEMENT SECTIONS  


K123715

REMOVAL


Symbol Meaning
K108827

Cut and Join Location

a.

After grinding off the hemming location, remove the outer panel.

K123803C01
6.5,3.167 6.333,3.167 6.333,3.167 6.073,2.583 false 6.542,3.083 6.854,3.24 0.313,0.156 10 false *a 5.792,0.76 6.104,0.917 0.313,0.156 10 false *b
*a Disc Sander *b Hemming Location




INSTALLATION


Symbol Meaning
K108831

Butt Weld
K108833

Spot MIG Weld
K108834

Body Sealer

a.

Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

NOTICE:

Do not close the drain hole.


HINT:

Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement to make contact.


K123804C01
2.5,3.667 2.333,3.667 2.333,3.667 2.25,3.344 false 2.552,3.583 2.865,3.74 0.313,0.156 10 false *1 6.104,3.073 6.417,3.229 0.313,0.156 10 false *a 5.281,1.375 5.594,1.531 0.313,0.156 10 false *b
*1 REAR DOOR PANEL OUTER - -
*a Drain Hole *b 10 mm (0.39 in.)



b.

Bend the flange hem with a wooden hammer and dolly.

HINT:

Bend the panel gradually so as not to distort it.


K123805C01
5.875,5.271 6.083,4.75 6.083,4.75 6.25,4.75 false 6.417,6.25 6.25,6.25 6.25,6.25 6.073,5.75 false 5.417,6.75 5.25,6.75 5.25,6.75 5.406,6.146 false 6.271,4.667 6.583,4.823 0.313,0.156 10 false *a 6.448,6.167 6.76,6.323 0.313,0.156 10 false *b 5.448,6.667 5.76,6.823 0.313,0.156 10 false *c
*a Cloth Tape *b Dolly
*c Wooden Hammer - -



c.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


d.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.