Home › Vehicle Exterior › BODY WELD POINT › DECK MOUNTING NO.1 BRACKET(for Single Cab Long Body)
BM3250E _01 Vehicle Exterior _040520 BODY WELD POINT _0187895 DECK MOUNTING NO.1 BRACKET(for Single Cab Long Body) F

BODY WELD POINT  DECK MOUNTING NO.1 BRACKET(for Single Cab Long Body)  ASSEMBLY REPLACEMENT  


K123742

K123965

HINT:
·

Use the same procedure for the RH and LH.

·

The procedure listed below is for the RH.



REMOVAL


Symbol Meaning
K108826

Cut with Disc Sander etc.

K123966C01
2.594,3.198 2.906,3.354 0.313,0.156 10 false *A 2.594,0.698 2.906,0.854 0.313,0.156 10 false *A 2.219,2.823 2.531,2.979 0.313,0.156 10 false *B 2.219,0.333 2.531,0.49 0.313,0.156 10 false *C
*A FRONT *B UPPER
*C LH - -



INSTALLATION


Symbol Meaning
K108830

Fillet Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


b.

Make sure that proper welding can be performed by setting up the welding conditions as necessary before performing work.


c.

Before installing the upper body, confirm the alignment of the upper body and frame.


d.

To prevent heat deformation, weld the right and left side of each part before continuing to the next part.

K123967C01
4.5,2.25 4.25,2.25 4.25,2.25 3.979,1.917 false 2.594,3.198 2.906,3.354 0.313,0.156 10 false *A 3.844,0.573 4.156,0.729 0.313,0.156 10 false *c 2.594,0.698 2.906,0.854 0.313,0.156 10 false *A 2.208,2.823 2.521,2.979 0.313,0.156 10 false *B 2.208,0.333 2.521,0.49 0.313,0.156 10 false *C 4.552,2.177 4.865,2.333 0.313,0.156 10 false *1 3.542,0.438 3.854,0.594 0.313,0.156 10 false *a 3.542,5.49 3.854,5.646 0.313,0.156 10 false *b 3.177,0.573 3.49,0.729 0.313,0.156 10 false *c 3.448,2.271 3.76,2.427 0.313,0.156 10 false *c 3.677,2.563 3.99,2.719 0.313,0.156 10 false *c
*A FRONT *B UPPER
*C LH - -
*1 REAR BODY MOUNTING BRACKET SUB-ASSEMBLY NO.1 - -
*a 80 mm (3.15 in.) *b 337 mm (13.27 in.)
*c 5 +/- 5 mm (0.20 +/- 0.20 in.) - -



e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.