Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › from 2016.03
BM3250E _V1 General _040398 INTRODUCTION _0200043 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED / RECONNECTED TO BATTERY TERMINAL  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system
Memorize steering angle neutral point Pre-crash safety system

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.