Home › Engine / Hybrid System › 2GD-FTV EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2015.06–2016.08
NM3250E _51 Engine / Hybrid System _040735 2GD-FTV EMISSION CONTROL _0189060 EMISSION CONTROL SYSTEM CO CONTROL F

2GD-FTV EMISSION CONTROL  EMISSION CONTROL SYSTEM  CONTROL  EMISSION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the emission control system are as follows:

Component Function

*1: Models with catalyst support control

*2: Models with UREA SCR system

ECM Controls the emission control system based on signals from each sensor.
Electric EGR Control Valve Assembly Actuated by the ECM, this valve controls the flow rate of EGR gas.
EGR Valve Position Sensor (Built into Electric EGR Control Valve Assembly) Detects the EGR valve position.
Diesel Throttle Valve Actuated by the ECM, this valve controls the flow rate of intake air.
No. 1 EGR Cooler Cools EGR gas.
No. 2 EGR Valve Assembly Switches the flow passage of EGR gas in 2 stages.
Differential Pressure Sensor*1 Monitors the differential pressure before and after the DPF to detect whether the DPF is clogged.
Exhaust Fuel Addition Injector Assembly*1 Injects fuel into the exhaust manifold according to signals from the ECM.
UREA Pump Control ECU*2 Controls the UREA SCR system based on signals from each sensor.
Exhaust Gas Temperature Sensor*1 Detects the exhaust gas temperature.
No. 2 Exhaust Gas Temperature Sensor*1
No. 3 Exhaust Gas Temperature Sensor*1
No. 4 Exhaust Gas Temperature Sensor*2
Air Fuel Ratio Sensor*1 Detects the oxygen concentration in exhaust gas.
NOx Sensor (Nitrogen Oxides Sensor)*2 Detects the concentration of NOx in the exhaust gas.



FUNCTION


a.

The main function of the emission control system is as follow:

Function Outline

*1: Models with catalyst support control

*2: Models with UREA SCR system

EGR Control This system is designed to help reduce and control NOx formation due to a reduction of peak temperature in the engine combustion chamber, which is accomplished by the introduction of an amount of inert gas into the intake manifold.
Catalyst Support Control*1 Determines the DPF catalyst conditions based on various signals, controls the injector assembly and exhaust fuel addition injector assembly, and controls the DPF catalyst conditions.
UREA SCR System*2 Urea solution is injected by the urea injector set to purify NOx in the exhaust gas.