Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › THROTTLE BODY
RM3250E _51 Engine / Hybrid System _037981 1GR-FE ENGINE CONTROL _0176367 THROTTLE BODY A

1GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

HINT:

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.

Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.

Install a new gasket to the intake air surge tank.


b.

Install the throttle body with motor assembly with the 4 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


c.

Connect the throttle body with motor connector.


d.

Connect the No. 4 water by-pass hose and No. 5 water by-pass hose, and slide the 2 hose clamps to secure the hose.


Hide 17705 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

a.

Attach the 4 clamps and install the air cleaner cap sub-assembly with No. 1 air cleaner hose.


b.

Tighten the hose clamp.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


c.

Connect the No. 2 ventilation hose to the No. 1 air cleaner hose, and slide the clamp to secure the hose.


d.

Connect the vacuum hose to the No. 1 air cleaner hose.


e.

Attach the 2 clamps and connect the intake mass air flow meter connector.


Hide 5.PERFORM INITIALIZATION

NOTICE:

Perform the following procedure after replacing the throttle body with motor assembly or any throttle body components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.


a.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.



b.

Connect the GTS to the DLC3 and clear the DTCs.

Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR


c.

Perform the "Inspection After Repairs".

Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


d.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

Standard idle speed:

650 to 750 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in N (neutral) or P.




e.

Enter the following menus: Powertrain / Engine / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 234 12

f.

Perform a road test and confirm that there are no abnormalities.