Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM3250E _51 Engine / Hybrid System _037981 1GR-FE ENGINE CONTROL _0176369 ACCELERATOR PEDAL A

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly

If applied, the accelerator pedal sensor assembly must be replaced.


a.
A344409

Disconnect the accelerator pedal sensor connector.


b.

Remove the 2 nuts and accelerator pedal sensor assembly.

NOTICE:
·

Avoid physical shocks to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.