Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM3250E _51 Engine / Hybrid System _037981 1GR-FE ENGINE CONTROL _0176370 MASS AIR FLOW METER G

1GR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY

a.
A356029C01
0.563,1.396 0.667,1.396 0.667,1.396 0.708,1.198 true 0.854,1.74 1,1.74 1,1.74 1.073,1.51 true 0.656,1.635 0.854,1.833 0.198,0.198 10 false *a 0.375,1.302 0.573,1.49 0.198,0.188 10 false *b
*a Platinum Hot Wire (Heater)
*b Temperature Sensor (Thermistor)


Perform a visual check for any foreign matter on the platinum hot wire (heater) and temperature sensor (thermistor) of the intake mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the intake mass air flow meter sub-assembly.


b.

Check the intake air temperature sensor (built into the intake mass air flow meter sub-assembly).

i.
A328407C03
0.99,0.438 1.094,0.438 1.094,0.438 1.375,1.177 true 1.563,1.177 1.875,0.469 1.875,0.469 1.99,0.469 true 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 1.969,1.188 2.125,1.385 0.156,0.198 10 false 1 1.823,1.188 1.979,1.385 0.156,0.198 10 false 2 1.677,1.188 1.833,1.385 0.156,0.198 10 false 3 1.521,1.188 1.677,1.385 0.156,0.198 10 false 4 1.365,1.188 1.521,1.385 0.156,0.198 10 false 5 0.771,0.396 1.083,0.594 0.313,0.198 10 false E2 2.052,0.406 2.365,0.604 0.313,0.198 10 false THA
*a Component without harness connected
(Intake Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 5 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the intake mass air flow meter sub-assembly.