Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG
RM3250E _51 Engine / Hybrid System _037981 1GR-FE ENGINE CONTROL _0176373 IGNITION COIL AND SPARK PLUG A

1GR-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of spark plug

·

Replacement of ignition coil assembly


Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 17126 1.REMOVE NO. 2 SURGE TANK STAY

a.
A344385

Remove the 2 bolts and No. 2 surge tank stay.


Hide 19500 2.REMOVE IGNITION COIL ASSEMBLY

a.

Disconnect the 6 ignition coil connectors.


b.
A356038

Remove the 6 bolts and 6 ignition coil assemblies.


Hide 19100P 3.REMOVE SPARK PLUG

a.

Remove the 6 spark plugs.