The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
17105
1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
17104
2.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
89467B
3.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
Disconnect the connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold.
Do not damage the air fuel ratio sensor.
89467B
4.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
Disconnect the connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold.
Do not damage the air fuel ratio sensor.