Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › PURGE VALVE
RM3250E _51 Engine / Hybrid System _037984 1GR-FE EMISSION CONTROL _0176390 PURGE VALVE G

1GR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650G 1.INSPECT PURGE VSV

a.

Inspect the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground


If the result is not as specified, replace the purge VSV.



b.

Check the operation of the purge VSV.

i.
A354990C01
0.615,0.927 0.802,0.927 0.802,0.927 1.052,1.292 true 1.823,1.865 1.823,1.406 true 0.417,0.823 0.615,1.021 0.198,0.198 10 false *a 1.771,1.885 1.969,2.073 0.198,0.188 10 false *b 0.708,1.396 0.906,1.583 0.198,0.188 10 false *c 2.74,1.781 2.948,1.99 0.208,0.208 10 false *d
*a Port F
*b Port E
*c Does not flow
*d Air


Check that air does not flow from port F when air is applied to port E.


ii.
A354991C01
1.458,1.844 1.458,1.385 false 0.354,0.865 0.5,0.865 0.5,0.865 0.646,1.229 true 1.844,1.094 2.104,0.438 2.104,0.438 2.281,0.438 true 1.833,1.188 2.083,1.417 2.083,1.417 2.271,1.417 true 0.167,0.76 0.365,0.958 0.198,0.198 10 false *a 1.406,1.875 1.594,2.073 0.188,0.198 10 false *b 2.302,1.76 2.5,1.958 0.198,0.198 10 false *c 2.323,1.323 2.479,1.521 0.156,0.198 10 false 2 2.333,0.344 2.49,0.542 0.156,0.198 10 false 1
*a Port F
*b Port E
*c Air


Apply battery voltage to the connector and check the purge VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air flows from port E to port F


If the result is not as specified, replace the purge VSV.