Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › SFI SYSTEM
RM3250E _51 Engine / Hybrid System _037981 1GR-FE ENGINE CONTROL _0176666 SFI SYSTEM L

1GR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION




INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration or frame number registration) when replacing the ECM.

Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION

·

Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).



HINT:

Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.



WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.



IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle.

The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition switch off LOCK Off (Lock)
Ignition switch ACC ACC On (ACC)
Ignition switch ON ON On (IG)
Engine Start START On (Start)