Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › CYLINDER HEAD
RM3250E _51 Engine / Hybrid System _037982 1GR-FE ENGINE MECHANICAL _0177656 CYLINDER HEAD A

1GR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 13734 1.REPAIR VALVE SPRING SEAT

a.
A326716C02
2.24,0.927 2.729,0.927 true 1.979,0.844 2.24,1.052 0.26,0.208 10 false 45° 2.729,1.5 2.927,1.698 0.198,0.198 10 false *a 3.073,0.833 3.333,1.042 0.26,0.208 10 false 30°
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.


b.
A326717C02
2.031,0.865 2.781,0.865 true 1.76,0.781 2.031,0.99 0.271,0.208 10 false 60° 2.719,1.521 2.958,1.74 0.24,0.219 10 false *a 3.083,0.667 3.354,0.875 0.271,0.208 10 false 45°
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


Intake Side:

If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.


c.
A326718C02
1.854,0.688 2.646,0.688 true 1.604,0.615 1.844,0.813 0.24,0.198 10 false 75° 2.719,1.5 2.917,1.688 0.198,0.188 10 false *a 3.083,0.667 3.333,0.854 0.25,0.188 10 false 45°
*a 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


Exhaust Side:

If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.


d.
A326719

Hand-lap the valve and valve seat with an abrasive compound.


e.

After lapping the valve by hand, clean the valve and valve seat.