Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PRESSURE PULSATION DAMPER
RM3250E _51 Engine / Hybrid System _037983 1GR-FE FUEL _0177661 FUEL PRESSURE PULSATION DAMPER A

1GR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17129 4.REMOVE INTAKE AIR SURGE TANK

Hide 23270 5.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A344539C01
2.51,0.406 2.646,0.406 2.646,0.406 2.771,0.521 true 2.323,0.333 2.542,0.531 0.219,0.198 10 true *1
*1 Fuel Pressure Regulator Holder


Remove the fuel pressure regulator holder from the fuel pressure pulsation damper assembly.


b.

Pull the fuel pressure pulsation damper assembly out of the fuel delivery pipe sub-assembly.


c.

Remove the O-ring from the fuel pressure pulsation damper assembly.