Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL FILTER
RM3250E _51 Engine / Hybrid System _037983 1GR-FE FUEL _0177662 FUEL FILTER A

1GR-FE FUEL  FUEL FILTER  REPLACEMENT  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 77704 4.REMOVE CHARCOAL CANISTER SUB-ASSEMBLY

Hide 23801P 5.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.
A344541

Detach the No. 1 fuel pipe sub-assembly from the fuel filter assembly.


b.

Disconnect the No. 1 fuel pipe sub-assembly from the fuel filter assembly.

Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION


Hide 77251B 6.DISCONNECT FUEL MAIN TUBE

a.
A344542

Disconnect the fuel main tube from the fuel filter assembly.

Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION


Hide 23300 7.REMOVE FUEL FILTER ASSEMBLY

a.
A344543

Remove the 3 nuts and fuel filter assembly.


Hide 23300 8.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter assembly with the 3 nuts.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 77251B 9.CONNECT FUEL MAIN TUBE

a.

Connect the fuel main tube to the fuel filter assembly.

Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION


Hide 23801P 10.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.

Connect the No. 1 fuel pipe sub-assembly to the fuel filter assembly.

Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION


b.

Attach the No. 1 fuel pipe sub-assembly to the fuel filter assembly.


Hide 77704 11.INSTALL CHARCOAL CANISTER SUB-ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION