Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly.
Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION
83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
2.REMOVE NO. 1 FUEL SUB-TANK
Disconnect the fuel with filter pump assembly connector and wire harness.
Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the clamp.
Disconnect the fuel tube and wire harness.
Using a screwdriver, detach the 3 claws from the claw holes.
Tape the screwdriver tip before use.
Using a screwdriver, detach the 2 claws from the claw holes and remove the No. 1 fuel sub-tank.
Do not damage the No. 1 fuel sub-tank.
Tape the screwdriver tip before use.
23220A
3.REMOVE FUEL WITH FILTER PUMP ASSEMBLY
Using a screwdriver, detach the 3 claws from the claw holes and disconnect the fuel with filter pump assembly.
Tape the screwdriver tip before use.
Disconnect the fuel with filter pump assembly connector and remove the fuel with filter pump assembly harness.
| *1 | O-Ring |
| *2 | Spacer |
Remove the O-ring and spacer from the fuel with filter pump assembly.