Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly.
Click hereEngine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION
23220A
1.INSTALL FUEL WITH FILTER PUMP ASSEMBLY
Perform "Inspection After Repair" after replacing the fuel with filter pump assembly.
Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Install the fuel with filter pump assembly harness and connect the fuel with filter pump assembly connector.
Apply a light coat of gasoline to a new O-ring.
| *1 | O-Ring |
| *2 | Spacer |
| *a | Supporter |
Install the O-ring and spacer to the supporter of the fuel with filter pump assembly as shown in the illustration.
Attach the 3 claws to the claw holes and install the fuel with filter pump assembly and suction filter assembly.
2.INSTALL NO. 1 FUEL SUB-TANK
Attach the 2 claws to the claw holes and install the No. 1 fuel sub-tank.
Attach the 3 claws to the claw holes.
Connect the fuel tube and wire harness.
Attach the claw on the end of the tube to the claw hole. Connect the tube to the 2 clamps on the fuel sub-tank.
Connect the fuel with filter pump assembly connector and wire harness.
83320
3.INSTALL FUEL SENDER GAUGE ASSEMBLY