Home › Engine / Hybrid System › 1GR-FE COOLING › THERMOSTAT › 2015.06–2016.01
RM3250E _51 Engine / Hybrid System _037986 1GR-FE COOLING _0177671 THERMOSTAT A

1GR-FE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
A343701

Do not remove the radiator cap sub-assembly, cylinder block drain cock plugs or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD)

Hide 16572 3.DISCONNECT RADIATOR HOSE OUTLET

a.

Slide the hose clamp and disconnect the radiator hose outlet from the water inlet sub-assembly with thermostat.


Hide 16031 4.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

a.
A340121

Remove the 3 nuts, water inlet sub-assembly with thermostat and gasket from the water inlet assembly.

HINT:

If the thermostat was not installed, cooling efficiency would be harmed. Even if the engine tends to overheat, do not remove the thermostat.