89467B
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
17105
2.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
| *a | Oval Shape |
|
Forward |
Install a new gasket to the cylinder head LH with the oval shape facing rearward.
Make sure the gasket is installed facing the proper direction.
Install the exhaust manifold sub-assembly LH with 6 new nuts.
Connect the air fuel ratio sensor connector.
17119
3.INSTALL NO. 2 MANIFOLD STAY
Install the No. 2 manifold stay with the 3 bolts.
89467B
4.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
17104
5.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
| *a | Oval Shape |
|
Forward |
Install a new gasket to the cylinder head sub-assembly RH with the oval shape facing forward.
Make sure the gasket is installed facing the proper direction.
Install the exhaust manifold sub-assembly RH with 6 new nuts.
Connect the air fuel ratio sensor connector.
17118
6.INSTALL MANIFOLD STAY
Install the manifold stay with the 3 bolts.
17410
7.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install the front exhaust pipe assembly to the No. 1 exhaust pipe support.
Using a wire brush, remove any foreign matter from the gasket installation surface.
Install a new gasket to the end of the front exhaust pipe assembly that connects to the exhaust manifold sub-assembly RH.
Do not reuse the gasket.
Connect the front exhaust pipe assembly to the exhaust manifold sub-assembly RH with the 2 new nuts.
Using a vernier caliper, measure the free length of the compression spring.
40 mm (1.57 in.)
If the free length is less than the minimum, replace the compression spring.
| *1 | Gasket |
| *a | Wooden Block |
Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the front exhaust pipe assembly.
Be sure to install the gasket so that it faces the correct direction.
Do not reuse the gasket.
Do not damage the gasket.
When connecting the tail exhaust pipe assembly, do not push in the gasket with the tail exhaust pipe assembly.
Connect the front exhaust pipe assembly to the tail exhaust pipe assembly with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.
Connect the heated oxygen sensor connector.
Attach the 2 clamps.
17450B
8.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
37140
9.INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
10.INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
53882F
11.INSTALL FRONT FENDER SEAL RH
53882F
12.INSTALL FRONT FENDER SEAL LH
53735B
13.INSTALL FRONT UPPER FENDER APRON SEAL RH
53735B
14.INSTALL FRONT UPPER FENDER APRON SEAL LH