Home › Engine / Hybrid System › 1TR-FE ENGINE CONTROL › THROTTLE BODY
RM3250E _51 Engine / Hybrid System _037997 1TR-FE ENGINE CONTROL _0181523 THROTTLE BODY G

1TR-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check for throttle control motor operating sounds.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check for operating sounds of the motor. Make sure that no friction noise is emitted from the motor.

If any friction noise exists, check the throttle body with motor assembly, the wire harness and the ECM.



b.

Inspect the throttle position sensor.

i.

Warm up the engine.


ii.

Turn the ignition switch off.


iii.

Connect the GTS to the DLC3.


iv.

Turn the ignition switch to ON.


v.

Turn the GTS on.


vi.

Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 234 12

vii.

Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is as specified.

Standard:

Value changes


HINT:

When checking the percentage, the shift lever should be in neutral.


If the result is not as specified, check the throttle body with motor assembly, the wire harness and the ECM.