22204
1.CHECK INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
Read the value using the GTS (MAF).
Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / MAF.
| Tester Display |
|---|
| MAF |
Wait 30 seconds, and then read the value on the GTS.
| GTS Display | Condition | Specified Condition |
|---|---|---|
| MAF | Idling | 1.0 to 5.0 gm/sec |
| 2000 rpm | 5.0 to 9.0 gm/sec | |
| 3000 rpm | 9.0 to 15.0 gm/sec |
If the result is not as specified, replace the intake mass air flow meter sub-assembly.
If the result is within the specified range, inspect the intake mass air flow meter sub-assembly.
Click hereEngine / Hybrid System>1TR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION