Home › Engine / Hybrid System › 1TR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM3250E _51 Engine / Hybrid System _037997 1TR-FE ENGINE CONTROL _0181533 HEATED OXYGEN SENSOR G

1TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A112088C02
1.26,0.76 0.771,0.76 false 2.667,0.76 2.188,0.76 false 0.771,1.667 0.896,1.667 0.896,1.667 1.271,1.448 false 0.5,0.677 0.781,0.865 0.281,0.188 10 false +B 2.75,0.677 3.24,0.885 0.49,0.208 10 false HT1B 0.5,1.573 0.813,1.781 0.313,0.208 10 false E2 0.115,0.094 0.333,0.271 0.219,0.177 10 false *a
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B) 20°C (68°F) 5 to 10 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.