The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the radio and display receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a1-3 (US1+) - a2-3 (US1+) | Always | Below 1 Ω |
| a1-2 (US1-) - a2-2 (US1-) | Always | Below 1 Ω |
| a1-3 (US1+) or a2-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| a1-2 (US1-) or a2-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG