Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER(for 2WD)
RM3250E _53 Suspension _038041 FRONT SUSPENSION _0182535 FRONT SHOCK ABSORBER(for 2WD) N

FRONT SUSPENSION  FRONT SHOCK ABSORBER(for 2WD)  DISPOSAL  


PROCEDURE

Hide 48520 1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

HINT:

Use the same procedure for the other front shock absorber.


a.
C323465C01
2.219,0.115 2.531,0.313 0.313,0.198 10 false *a
*a Approximately 35 mm


Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.


b.

Using a drill or similar tool, slowly make a hole approximately 35 mm (1.38 in.) from the top end of the shock absorber and discharge the gas inside of it.

NOTICE:
·

The gas is colorless, odorless and harmless.

·

Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.